📲Assigning Your Callsign
There are two ways that you need to go ahead and assign your callsign within the department, One would be via /callsign E-00 and via /dispatchlarge. Below I will show you how to go ahead and do show you how both of these steps now.
Step One:
For step one you will need to go ahead and check your call sign within the city roster. Please look at the navigation bar to look at the roster.
Step Two:
Within city you will need to go ahead and type /callsign E-## to allow your callsign to show on the Blip within the City GPS.
This will allow to all active units from EMS and the police department.
Step Three:
After you have done step two, you will need to go ahead and press L or /dispatchlarge this will bring up the City Control Panel that will go ahead and show Dispatch and all units and you will also get calls from here.
Step Four:
With this open you will then need to go ahead and press the wrench within the top left. This will give show you the settings for this.
Step Five:
Once you have got this please go ahead and click on the Update Callsign and enter your call sign within this format [E-00] this will allow everyone to know your callsign within the department and the police.
Remember that you are required to do all of the steps that are listed below. If you fail to do this you will be asked once and after this you will recive a warning from a high command member.
Last updated